Foxconn H61MXV Series - BIOS Configuration; Create RAID in BIOS

5
73
5-2 BIOS Conguration
1. Enter the BIOS setup by pressing <DEL> key during the POST(Power On Self Test).
2.Usethearrowright/leftkeystoselectthe“Advanced
” menu from, then use the
arrow up/down keys to select the
“SATAConguration”itemandpress<Enter>togo
tothecongurationitems.
3. Press <Enter> to select and set the “SATA Mode” option to [RAID Mode].
4.Press<F4>tosavethesettingthenPCwillrebootitself.
5-3 Create RAID in BIOS
Enter RAID BIOS Setup
When BIOS is restarted, it will display a message asking you to press <Ctrl>+<I> keys
simultaneously to enter the main menu of Intel
®
Matrix Storage Manager Option ROM
Utility.Pressthe<Ctrl>+<I>toenterCongurationUtility.
Intel(R)MatrixStorageManageroptionROMv5.0.0.1011ICH9Rw6AID5
Copyright(C)2003-04IntelCorporationAllRightsReserved.
1. Create RAID Volume 3. Reset Disks to Non-RAID
2.DeleteRAIDVolume  4.RecoverVolumeOptions
5.Exit  
RAID Volume :
NoneDened.
Physical Disks:
Port Drive Model Serial # Size Type/Status(Vol ID)
 0 HitachiHDS72161 PVF904Z21G2JZM 149.0GB Non-RAID Disk
1 ST380811AS 5PS1TAGW 74.5GB Non-RAID Disk
 2 SAMSUNG HD161HJ S0V3J9APA30524 149.0GB Non-RAID Disk
3 ST380815AS 5RW1CA37  74.5GB Non-RAID Disk
Intel(R)RapidStorageTechnology-OptionROM-10.0.0.1032
Copyright(C)2003-10IntelCorporation.AllRightsReserved.
[ DISK/VOLUMEINFORMATION ]
[ MAIN MENU ]
1. Create RAID Volume
[↑↓]-Select[ESC]-Exit[ENTER]-SelectMenu
Version 2.02.1205. Copyright (C) 2010 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2010 American Megatrends, Inc.
SATA Configuration
SATA Mode [RAID Mode]
SATA Port1 Not Present
SATA Port2 Not Present
SATA Port3 Not Present
SATA Port4 Not Present
→ ←: Select Screen
↑ ↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
(1) IDE Mode. (2) AHCI Mode.
(3) RAID Mode.
Advanced