NAGA PRO User Manual
50
in detail whether the hardware installation is correct (especially whether the arm is locked in
place, the battery compartment cover is tightly locked, whether the landing gear is locked,
whether the external load is installed firmly, the direction of the propeller, etc.). After
confirming that there is no problem, perform the following steps :
Turn on your rc transmitter
Insert the battery into the aircraft. The flight controller status light should flash red and
blue alternately (selfcheck process). Do not move the aircraft during the self-check.
Pre-Arm will run automatically. After a normal self-check, the blue light or green light
will flash, indicating that the Pre-arm has no error and can be unlocked. If the yellow light
is flashing, please refer to the FAQ summary to eliminate the error.
Set the correct mode: Set the mode to Stabilize, ATLhold or Loiter (outdoor GPS lock is
required). Novices are recommended to use Stabilization or Altitude hold mode.(For this
product, press the A button on the bottom of the remote controller to enter Alt hold mode)
Unlock the safety switch: Press and hold the unlock safety switch until the safety LED is
always on (flashing means lock and does not output pwm signal, and always on means
unlocking and output pwm signal) (the safety switch of this product is disabled, so the
user can omit this step)
Arm the aircraft: There are two ways to unlock the autopilot, which can be unlocked
through the ground control station or the remote controller.
Unlock through the remote controller. lower the RC throttle to the lowest position,
and the YAW channel to the far right for 2 seconds to unlock it, and then return the YAW
channel to the center.
To Next Page
Loading...