NAGA PRO User Manual
52
Take off: raise the throttle to take off, and control the direction according to the attitude.
(if the novice is not familiar with the control, you can practice the flight simulator first, so
as to avoid the explosion of the aircraft and the loss of personnel and property)
If there is no operation within 15 seconds after unlocking, it will be automatically locked.
After unlocking, the ideal attitude is too different from the actual attitude it will be
automatically locked.(Such as hitting the roll bar sharply or shaking the aircraft with your
hands )
3.2 Disarm the drone
Perform the following operations to disarm the drone:
Check your flight mode switch, set to Stabilize, Alt Hold or Loiter.
Keep the throttle at the lowest and the direction YAW to the left.
Unplug the aircraft battery.
Turn off the remote control transmitter.
4. Take-off Precautions
It is best to use the Stabilize mode to take off for the first time. Make sure that the aircraft is
flying normally before switching to another mode. The throttle control mode of the stabilize
mode is linear, so the range of throttle control needs to be relatively small.
After flying in the stabilize mode for a period of time, if the altitude stays above 1 m, you can
switch to other functional modes such as altitude hold, fixed point, etc. The throttle control
logic of altitude hold and fixed point modes is different. There is a dead zone in the neutral
position of the throttle to maintain altitude. Push up, the plane goes up, push down, the plane
goes down.
Note: Before switching to another function mode, you must first understand the characteristics
of the flight mode.
六．Automatic Mission Planning
Flight planning is one of the most important functions in MP: the average player can use it to
plan the simplest flight missions, including height control of each waypoint, stay time, camera
trigger, various condition triggers, channel triggers, and even automatic take-off and landing
planning, etc. Industry users can also do surveying and mapping planning and so on.
To Next Page
Loading...