Foxtech Naga Pro MX16 - 十．How to Use QGC

NAGA PRO User Manual
64
points:
 Check if the frame setting X or + is correct
 Check if the ESC serial number is correct
 Check if the motor rotation is correct
 Whether the propeller direction is correct and whether the wind is blowing downwards
 Whether the accelerometer calibrates correctly
 Whether the ESC throttle is synchronized
2. The aircraft cannot take off when the motor rotates or the motor will not rotate
when unlocked:
 Check whether the wind is blowing downwards (propeller installed incorrectly, motor
turning incorrectly)
 Insufficient power? Check whether the propeller size matches the battery voltage in the
motor parameters
 The motor does not respond and keeps screaming: the throttle range of the remote
controller is not calibrated.
3. Controlling the aircraft to fly forward but actually flying backward or controlling to
left but actually to right:
 The control channel of the remote controller is reversed, just adjust the corresponding
channel of the remote controller menu to reverse it.
4. The flight controller cannot detect the remote controller signal:
 If it is the first time to use: first check whether the receiver is paired successfully. Whether
the receiver output is PPM or SBUS protocol. If not, please use a PPM encoder.
 If it was normal before, it suddenly fails: Maybe the receiver is faulty or the IO of the
flight controller is faulty
 After flashing the PX4 native firmware, it is abnormal: it may be that the IO firmware or
BootLoader has been broken.
十．How to Use QGC
For the use of QGC ground station, please refer to QGC official website:
https://docs.qgroundcontrol.com/master/en/