Maintenance and care
101
On both sides, the brush is provided with pins
that are snapped in clips on the sword.
• Slightly lift the brush and pull it off the
sword in the direction of the arrow.
• Clean brush or replace with a new one.
• Moisten a new brush before inserting it.
• Hold the brush as shown in the figure.
– The bristles must face down.
– One leg of the leg spring is located in the
brush groove and the other leg in the sword
slot.
• Put the rear pin
into the clip of the sword as
indicated by the arrow.
• Then carefully snap the front pin
into the
clip of the sword.
To Next Page
Loading...