frako PQC - PQC Overview

Description of the menu | 37
FRAKO | Operating Manual | Power Quality Controller – PQC
6.2.1 PQC overview
Main menu > Display > PQC overview
All measurement readings and parameters relevant to power factor correction are
shown here.
6.2.1.1 Overview
Main menu > Display > PQC overview > Overview
cosφ Display of the momentary value of cosφ
Capacity utilization The ratio of the momentary switched-in capacitance to the
total available capacitance, expressed as a percentage
(0%=no capacitors switched in, 100%=all capacitors
switched in).
Control Auto / Man and active control profile
Alarm Flashes if an alarm is present.
Regeneration Flashes if power is being fed in to the supply network
Note
If Alarm flashes, pressing the key will display the list of active alarms and
messages.
6.2.1.2 Capacity utilization
Main menu > Display > PQC overview > Cap. utilization
Capacity utilization The ratio of the momentary switched-in capacitance to the
total available capacitance, expressed as a percentage.