frako PQC - About PQC; Factory Settings

66 | Description of the menu
Power Quality Controller – PQC | Operating Manual | FRAKO
6.3.7.6 Reset Alarm history
Main menu > Parametrization > Service > Reset Alarm history
Reset all alarms saved until now.
6.3.7.7 Service
Main menu > Parametrization > Service > Service
Optional service functions
Temp. I/O update Software update mode for Temp.
I/O Temp. I/O CLI for FRAKO Service
IoT update Software update mode for IoT
IoT CLI for FRAKO Service
Frakobus update Software update mode for Frakobus
6.4 About PQC
Main menu > About PQC
This item gives information about the instrument:
FW Firmware version number
HW Hardware version number
SN Serial number
Sys Time Operating hours
6.5 Factory settings
Menu Parameter Setting
Network parameters (Section 6.3.1 “System parameters”)
Network parameters
Nominal voltage 400 V
Nominal frequency Auto
Transformer ratio (I) 1
Transformer ratio (V) 1
System parameters (Section 6.3.2 “PFC Equip. parameter”)
System parameters
Choke factor 7 %
Control parameters (Section 6.3.3 “Control parameters”)
Control parameters
Cyclic switching ON
Discharge time 60 s
Fixed stages 0