8 | Safety
Power Quality Controller ā PQC | Operating Manual | FRAKO
2.5 Relevant standards
Installation and commissioning of the instrument in industrial plant must be carried out
in strict compliance with the following standards:
ā EN 61508-1:2011-02; VDE 0803-1:2011-02
Any other laws, standards, regulations and safety rules (IEC, EN, VDE, etc.) relevant to
this product and the protection of persons and assets must be observed. In Germany,
it is essential to comply with the Equipment Safety Act (GSG) and the regulations of
the German Social Accident Insurance Institutions. In other countries, the equivalent
local regulations must be followed.
2.6 Repair
Should repair work be necessary, the customer or user must contact the manufacturer
of the PQC: FRAKO Kondensatoren und Anlagenbau GmbH, Tscheulinstrasse 21A,
D-79331 Teningen, Germany, www.frako.com.
To Next Page
Loading...