Framery Q (UL) Meeting Maggie
8. Measure the straightness of the hinge-side glass frame with a spirit level. Adjust if
needed and install with M8x20 screws (2 pcs) and M8 washers (2 pcs). Use a hex key.
9. Tighten the nylon screws (2 pcs each side) on the sides of the front of the pod with a
flat-head screwdriver.
Note: The glass adjustment screws are only for stiffening the glass structure.
Tighten the screws until you feel resistance, then loosen half a turn. Do not
overtighten.
52
Installation instructions
info@frameryacoustics.com
To Next Page
Loading...
