What to do if Continuous hot water detected above thermal limit when Franklin Electric Water System is not running?
If continuous hot water is detected above the thermal limit when your Franklin Electric Water System unit is not running, supply cold water to the pump.
What to do if Franklin Electric Water System shows Overvoltage?
If you are experiencing an Overvoltage (input voltage higher than +10%) issue with your Franklin Electric Water System, consult a licensed electrician to check and correct the supply voltage.
Why won’t my Franklin Electric Industrial Equipment turn on?
If your Franklin Electric Industrial Equipment unit won’t turn on, first, press the push button on the user interface. A dry run fault could also be the reason. Check the inlet water supply and valving and make sure the outlet pressure switch setting is not adjusted too high. Overvoltage (input voltage higher than +10%) or undervoltage (input voltage lower than -10%) can also cause this issue, so consult a licensed electrician to check and correct the supply voltage. Other potential causes include flow sensor component failure or temperature sensor fault, which require consulting a professional for replacement parts or unit. Overheating due to excessive water temperature or continuous hot water detected above thermal limit when the unit is not running may also be the reason; in this case, ...
Covers safety alert symbols, DANGER, WARNING, CAUTION, NOTICE, and electrical shock risks.
Detailed steps for both plumbing connections and electrical wiring for installation.
Explains the need for priming, minimum pressure, and the step-by-step priming process.
Guides on operating the unit, impact of leaks, and how to adjust performance settings.
A guide to common conditions, indicator lights, possible causes, and corrective actions.
General| Brand | Franklin Electric |
|---|---|
| Model | Inline 400 |
| Category | Water Pump |
| Language | English |
To Next Page
