TCA200 Rev171031
13
Table 2. Error Codes
Table 3. Fault Warning Codes
RPM
Display
Message
Display
Probable Cause
Note: Not all inputs are used for all engines. For systems that use
a datalink to pass information the datalink cable and connectors or
ECM programming would be the probable cause.
E01 No Data
>Datalink cable not connected / connected to wrong port
>Broken wire / bad connector contact on datalink cable
E02 No RPM
Engine RPM not detected
>Datalink cable not connected / connected to wrong port
>Engine not running / ignition key on
E03 No Trans T.
Sensor
No Transmission Data Detected
>Datalink cable not connected / connected to wrong port
>Broken wire / bad connector contact on datalink cable
E04 No Eng Oil
Sensor
No Engine Oil Pressure Data Detected
>Datalink cable not connected / connected to wrong port
>Broken wire / bad connector contact on datalink cable
E05 No D.
Sensor
No Discharge Pressure Sensor Detected
>Sensor cable not connected
>Broken wire / bad connector contact on sensor cable
>Defective pressure sensor
E06 No I.
Sensor
No Intake Pressure Sensor Detected
>Sensor cable not connected
>Broken wire / bad connector contact on sensor cable
>Defective pressure sensor
E07 No Eng
T.Sensor
No Coolant Temperature Data Detected
>Datalink cable not connected / connected to wrong port
>Broken wire / bad connector contact on datalink cable
RPM
Display
Message Display Description
F01 Hi Batt
High Battery Voltage
F02 Low Batt
Low Battery Voltage
F03 Hi Trans
High Transmission Temperature
F04 Low Oil
Low Engine Oil Pressure
F07 Hi Eng T.
High Engine Coolant Temperature
F08 No Water
Out of Water Mode
F09 No Resp
Engine Does Not Respond
To Next Page
Loading...