TCA200 Rev171031
18
Detailed Information
The four LED bar graphs provide a constant display of the safe operating ranges for
engine oil pressure, engine coolant temperature, transmission temperature, and battery
voltage. They do not show exact numbers or units of measure. Detailed information
is shown in the message display when the MENU button is pressed. Engine hours and
pump hours are also shown.
Show Detailed Information
Note: Detailed information is a display only mode and no changes can be
made to the data.
The MENU button allows the operator to gain access to detailed information. Each
time the MENU button is pressed the display scrolls to show the next value.
The message display will show the following:
Eng Oil ###PSI (programmable for kPa or Bar)
Eng Temp ###°F (programmable for °C)
Trans T. ###°F (programmable for °C)
Batt VDC ##.#
Eng Hrs ####
Pump Hrs ####
The message display reverts to normal operation after 20 seconds if no buttons are
pressed or immediately when a button other than the MENU button is pressed.
To Next Page
Loading...