FRC TotalControl 200 - TCA200 Programming Functions; Software Revision and Date Programming

To Next Page

To Previous Page

TCA200 Rev171031

PROGRAMMING

The following program functions are always available to view and change:

P1 - Software Program Revision Number - Read Only

P2 - Product Manufacturing Date - Read Only

P3 - Set Current Date - Read/Write

P4 - Set Current Time - Read/Write

P5 - Retrieve Fault Codes - Read Only

Access Program Features

Note: When the program (P) code is ashing in the PUMP INTAKE display,

press the INC or DEC button to scroll through the P-codes or press the

SILENCE button to exit the programming mode.

1. Press the SILENCE button and hold it until the RPM display shows four dashes – – – –

and the message display shows ENTER--- . Release the button.

Result: P 1 ashes in the PUMP INTAKE display. The message display shows the

program revision number PROG REV V100.03.

2. Press the INC button.

Result: P 2 ashes in the PUMP INTAKE display. The message display shows the

manufacturing date MFG DATE 09AUG'07 (ddmmm'yy).

3. Press the INC button.

Result: P 3 ashes in the PUMP INTAKE display. The message display shows the

current date SET DATE 17AUG'07.

4. To Change the Date: (If not go to step 5.)

a. Press the MENU button.

Result: P 3 stops ashing. The message display shows the current date with the

year ashing.

b. Press the INC or DEC button to change the year.

c. Press the MENU button.

Result: The month ashes.

d. Press the INC or DEC button to change the month.

e. Press the MENU button.

Result: The day ashes.

f. Press the INC or DEC button to change the day.

g. Press and hold the SILENCE button to store the new date.

Result: P 4 ashes in the PUMP INTAKE display. The message display shows

SET TIME 10:30AM . Go to step 6.