FRC TotalControl 200 - TCA200 Programming Time and Fault Codes; Time Setting and Fault Code Retrieval

To Next Page

To Previous Page

TCA200 Rev171031

5. Press the INC button.

Result: P 4 ashes in the PUMP INTAKE display. The message display shows SET

TIME 10:30AM .

6. To Change the Time: (If not go to step 7.)

a. Press the MENU button.

Result: P 4 stops ashing. The message display shows the current time with the

AM or PM ashing.

b. Press the INC or DEC button to change AM or PM.

c. Press the MENU button.

Result: The minute ashes.

d. Press the INC or DEC button to change the minutes.

e. Press the MENU button.

Result: The hour ashes.

f. Press the INC or DEC button to change the hours.

g. Press and hold the SILENCE button to store new time.

Result: P 5 ashes in the PUMP INTAKE display. The message display shows

WARNING CODES.

7. Press the MENU button.

Result: P501 shows in the PUMP INTAKE display and the message display shows

the most recent error or fault code. The date and time that the error or fault code was

recorded scrolls in the message display.

8. Press the INC or DEC button to scroll through 20 stored error and fault codes.

Note: FMI codes are displayed starting at P521.

9. Press and hold the SILENCE button.

Results: P 1 ashes in the PUMP INTAKE display.

10. Press the INC or DEC button to scroll through the P-codes or press the SILENCE button

to exit programming mode.