35| USER MANUAL
RADIO MAPPING
ALTA can be used with a variety of radio controllers. Different radio controllers can
map functions to different channels, so properly mapping controller channels to
ALTA functions is an important step before flying. Radio mapping is performed using
the ALTA App.
This section describes the steps required to complete radio mapping.
If you are uncertain about your channel mapping, obtain assistance from an
experienced pilot or from Freefly Customer Support.
CONFIGURATION JUMPER
A small jumper is used to prevent motor operation while configuring radio mapping
parameters. With the jumper in place, the motors may operate, but channel
mapping is prevented. With the jumper removed, channel mapping may take place,
but motor operation will be prevented.
To remove or replace the Configuration Jumper:
1. Locate the closeout panel where the jumper is installed
2. Remove the side closeout panel with the jumper using a 1.5mm hex driver
To Next Page
Loading...
