78| USER MANUAL
AFTER EVERY FLIGHT
1. Mode Switch MANUAL
2. Home Switch CENTER POSITION
3. Arm Enable Switch ENABLE DISARM
4. ESCs and Motors DISARM and STOP
5. Arm Enable Switch DISABLED
6. Orientation Lights VERIFY FLASHING GREEN
7. Status LED VERIFY SLOW FLASHING WHITE
8. ALTA App CHECK for warnings
9. Batteries DISCONNECT and REMOVE
10. Radio Controller Power AS REQUIRED
11. Aircraft Condition INSPECT
12. Motor and Prop Condition INSPECT
13. Battery Condition INSPECT
AMPLIFICATION
Upon landing, disarm the motors by holding full low throttle and full left yaw. This
is typically done on the left radio control stick by moving it to the bottom left corner
with mode 2 controllers. Disarming can only be done while in Manual Mode. If
configured, set the Arm Enable Switch to ENABLE DISARM. Once the motors are
disarmed, the Orientations Lights will flash green and the Status Light will slowly
flash white, indicating it is safe to approach ALTA.
WARNING
Only approach ALTA after confirming that it is disarmed by
verifying the Status Light and Orientation Light colors.
The downwash from the props can disturb debris. This debris can be ingested by
the props or motors and cause damage. After the flight, ensure there is no damage
to the props and that the motors still spin freely and quietly. Take extra care when
operating in areas with large amounts of debris, such as in sand, dirt, or gravel.
After flight is also a good time to check a battery pack’s condition. Always refer
to the battery manufacturer’s recommendations for inspection and replacement
intervals or requirements.
To Next Page
Loading...
