95| USER MANUAL
FIRMWARE UPDATE PROCESS
NOTE
Carefully follow in-app instructions for saving and restoring ALTA
configuration settings during the firmware update process.
WARNING
Remove propellers before performing a firmware update.
Test radio channels, arming and disarming behavior after
firmware updates to ensure radio mapping has been preserved.
Incorrect radio mapping can lead to loss of control.
SYNAPSE firmware is updated using the ALTA App. New app updates may include
new firmware installations. To update firmware:
1. Provide power to ALTA
a. Install and plug in a fully charged flight pack or
b. Plug in the USB-Futaba cable to an available receiver
port (Futaba and PPM receivers only)
2. Open the ALTA App
3. Open Monitor > Updates
4. The latest firmware included with the app release is compared with the ALTA
firmware. If a new release is available, the app will provide a notification
5. Tap the Install button in the App if an update is available
6. Wait until the firmware is loaded and ALTA has booted—
Do not power down ALTA during this time
7. Reload saved configuration
To Next Page
Loading...
