76| USER MANUAL
BEFORE TAKEOFF
1. Prop Area CLEAR
2. Mode Switch MANUAL
3. Home Switch CENTER POSITION
4. Radio Controller VERIFY CORRECT MODEL
5. Telemetry (if equipped) CHECK OPERATION
6. Arm Enable Switch ENABLE ARM
7. ALTA ARM
8. Status Light VERIFY OFF
9. Orientation Lights VERIFY USER-DEFINED COLOR
10. Motors START and VERIFY OPERATION
11. Flight Controls VERIFY CORRECT
12. Throttle ADVANCE
AMPLIFICATION
Prior to start, check the surrounding area to ensure people and objects are clear
of ALTA and its props. Also ensure that there are no people or objects between the
ALTA’s takeoff location and its intended flight path.
WARNING
ALTA’s props spin at a high RPM, and the ends of the blades
move at high speeds. ALTA’s props can cause severe injury
or death or cause damage to objects while they are rotating.
Always ensure the area surrounding the props and ALTA is
clear of people or objects prior to starting the ALTA’s motors.
ALTA can only be armed for flight when it is in the Manual Mode, and the Home
Switch is in the middle position. If an Arm Enable Switch is configured, it must be
placed in an ENABLE ARM position. To arm, hold full low throttle and full left yaw.
WARNING
Do not approach ALTA while it is armed.
To start the motors, hold full low throttle and full right yaw. Ensure that all the
To Next Page
Loading...
