Friedrich VRPXEMRT2 - Testing the Wall Controller

21
Testing the Wall Controller
Following the Wall Controller conguration, test if the Wall Controller is controlling
the VRP
®
or FreshAire
®
PTAC unit.
• Press the “Power” button to turn the Wall Controller ON;
• Press the “Up” and “Down” buttons to change the temperature set point
above and below the current room temperature to test if the Wall Controller
initiates heating and cooling - the VRP
®
or FreshAire
®
PTAC should turn
heating and air conditioning on and o󰀨.
• Change the fan speed by touching “Fan” button to test if the Wall Controller
is controlling the fan speed.
Wall Controller Conguration