9
Wall Controller Wiring Installation
There are four sets of connections for the VRPXEMRT2 Wall Controller. The
supplied cable from the VRPXEMRT2 Wall Controller as shown in Figure 1,
has four color coded wires. Each of these wires must be connected to two Cat6
wires (not supplied) as shown in Figure 2. Each connection is made with a lever
type connector. Four connectors will be needed to complete unit wiring. Each
connector is capable of connecting three wires.
Figure 1
Figure 2
WIRE COLOR LABEL
Blue
Connection 1
V+
Red
Brown/White
Green
Connection 2
D-
Blue
Orange
White/Green
Connection 3
D+
Brown
White/Orange
White/Blue
Connection 4
V-
Green
Brown
To Next Page
Loading...
