Friedrich VRPXEMRT2 - Wall Controller Configuration

CONFIGURATION
BUTTON
16
Wall Controller Con guration
Once the Wall Controller is powered, Wall Controller con guration settings will
appear on the Wall Controller screen.
In order to properly operate the VRP
®
or FreshAire
®
PTAC unit:
• Set the Wall Controller clock;
• Enter the room number;
• Con gure the Equipment Type
• Select Energy Savings Preset;
The Wall Controller con guration screens have a 30-second time-out. If no action
is taken within thirty (30) secondss, the Wall Controller will exit con guration
settings.
NOTE: You can access Wall Controller Con guration settings at any time by
pressing the “Con guration” button.
NOTE: If the Wall Controller is connected to a network, the equipment and the
energy saving settings con gured on the Wall Controller will be ignored and the
settings con gured on the Remote Management Website will be applied.