Friedrich VRPXEMRT2 - Programming a Wall Controller with a Network Programmer

7
Programming a Wall Controller with a Network Programmer
In case of Network Installation with Remote Management, the Wall Controller
must be programmed with a Network Programmer specic to the property before
the installation.
Wall Controller must not be powered during the pairing procedure.
• Plug one programmer connector into the Wall Controller;
• Push the black button on the programmer. The red light on the programmer
should turn on and remain steadily lit; If the red light on the programmer
is blinking or is not steadily lit, unplug the programmer from the Wall
Controller and repeat the steps above.
• Unplug the programmer from the Wall Controller;
Before You Begin