Friedrich VRPXEMRT2 - Wall Controller Installation

8
Wall Controller Installation
• Unplug the VRP
®
or FreshAire
®
PTAC unit;
• Remove the Wall Controller cover;
• Connect the supplied Wiring Harness to the wiring in the wall;
• Plug the wiring connector into the Wall Controller;
• Use the supplied wall anchors and mounting screws to secure the Wall
Controller to the wall;
• Follow the “Wall Controller Conguration” instructions;
• Replace the Wall Controller cover
• Plug in the VRP
®
or FreshAire
®
PTAC unit.
V+
D-
V-
D+