5
Introduction
Friedrich VRPXEMRT2 Energy Management Wall Controllers deliver
unprecedented energy savings without compromising occupant comfort.
An Integrated occupancy sensor uses a combination of motion and thermal
sensing technologies for accurate occupancy detection. Reliable occupancy
detection allows for energy savings when rooms are unoccupied.
Energy saving presets eliminate the guesswork and make it easy to adjust the
energy saving settings. (Patent Pending)
The Wall Controller has RS485 connectivity needed for connecting the Wall
Controller to Friedrich’s VRP
®
and FreshAire
®
PTAC units with RS485 interface.
Built-in wireless mesh-networking enables optional remote management.
FOR INSTALLATION OF NETWORKING WALL CONTROLLERS WITH REMOTE
MANAGEMENT, REFER TO THE NETWORK INSTALLATION MANUAL.
LOGIN TO THE REMOTE MANAGEMENT WEBSITE TO CONFIRM
THE SERVER IS CONNECTED TO THE INTERNET BEFORE
INSTALLING WALL CONTROLLERS. DO NOT INSTALL WALL CONTROLLERS IF
THE SERVER IS NOT CONNECTED TO THE INTERNET. STOP THE INSTALLATION
AND CONTACT TECHNICAL SUPPORT. START BY FIRST INSTALLING A WALL
CONTROLLER IN THE ROOM CLOSEST TO THE SERVER.
LOG IN TO REMOTE MANAGEMENT WEBSITE TO CONFIRM THAT THE WALL
CONTROLLER IS ON THE REMOTE MANAGEMENT WEBSITE WITH THE
CORRECT ROOM NUMBER. CONTINUE BY INSTALLING ADDITIONAL WALL
CONTROLLERS IN ADJACENT ROOMS ONLY AFTER CONFIRMING THAT
INSTALLED WALL CONTROLLER(S) HAVE CONNECTED TO THE WIRELESS
NETWORK AND THE REMOTE MANAGEMENT WEBSITE .
IF INSTALLED WALL CONTROLLER(S) ARE NOT CONNECTING TO THE
NETWORK AND DO NOT APPEAR ON THE REMOTE MANAGEMENT WEBSITE
WITH THE CORRECT ROOM NUMBER, STOP THE INSTALLATION AND CONTACT
TECHNICAL SUPPORT THE ROOMS FURTHEST AWAY FROM THE SERVER
SHOULD BE INSTALLED LAST.
To Next Page
Loading...
