Friedrich VRPXEMRT2 - Accessing the Wall Controller Settings; Custom Energy Savings Settings

CONFIGURATION
BUTTON
22
Custom Energy Savings Settings
If you don’t want to use the one of the energy saving presets listed on page
15 and detailed in the Appendix 1, you can enter the custom energy savings
settings.
Accessing the Wall Controller Settings
• Press and hold the “Con guration” button until the  rst Wall Controller
settings screen appears.
The Wall Controller must be turned on to access the Wall Controller settings.
NOTE: If the Wall Controller is connected to a network, the equipment and the
energy saving settings con gured on the Wall Controller will be ignored and the
settings con gured on the Remote Management Website will be applied
NOTE: You can access Wall Controller Settings by pressing and holding the
“Con guration” button.