Installing FRITZ!Box Fon in Windows 2000
FRITZ!Box Fon – 2 Starting FRITZ!Box Fon Operation 25
Installing FRITZ!Box Fon in Windows 2000
Administrator rights are required to install the driver soft-
ware in Windows 2000.
1. The Windows 2000 “Found New Hardware Wizard”
starts automatically. Follow the instructions displayed
on the screen.
2. When asked “What do you want Windows to do?”, se-
lect the option “Search for a suitable driver for my de-
vice (recommended)”. Confirm with “Next”.
3. In the next window, select “CD-ROM drives” as the
source for the driver files. Confirm with “Next”.
4. The program reports that a driver was found. Click
“Next” to install the driver.
Then you are informed that a driver for the FRITZ!Box
Fon has been found.
5. Once the files have been copied onto your computer,
conclude this step of installation by clicking “Finish”.
FRITZ!Box Fon is now connected and ready for operation.
You can only connect to the Internet if Internet access is con-
figured. See the section “Basic Configuration of FRITZ!Box
Fon” on page 28 for information about how to configure an
Internet connection.
Installing FRITZ!Box Fon in Windows 98
Insert the FRITZ!Box Fon CD in your CD-ROM drive to start the
Installation Help automatically. If the Installation Help does
not start automatically, open the INTRO.HTM file on the
FRITZ!Box Fon CD. Follow the instructions in the Installation
Help to install FRITZ!Box Fon at your computer’s USB port.
If you would like to install FRITZ!Box Fon without this Installa-
tion Help, first follow the instructions in the section “Con-
necting the USB Cable” and then perform the following
steps:
1. Windows 98 detects a new plug-and-play device to be in-
stalled. Follow the instructions displayed on the screen.
FRITZ!Box_Fon-e.book Seite 25 Donnerstag, 4. November 2004 2:08 14
To Next Page
Loading...
Need help?
General
