Froling PECO - Install the Brackets for Accessories

52 pages

Save Page as PDF

To Next Page

To Previous Page

Assembly | 5

M2320121_en | Installation instructions Pellet boiler PECO 45

5.10.2 Install the brackets for accessories

r Using appropriate fasteners, attach the brackets to the wall on the boiler

r Attach the accessories to the brackets

Main Page

Table of Contents2
General4
About this Manual4
Safety5
Hazard Levels of Warnings5
Qualification of Assembly Staff6
Personal Protective Equipment for Assembly Staff6
Design Information7
Overview of Standards7
General Standards for Heating Systems7
Standards for Structural and Safety Devices7
Standards for Heating Water7
Regulations and Standards for Permitted Fuels8
Installation and Approval8
Installation Site8
Chimney Connection/Chimney System9
Connection Line to the Chimney9
Measuring Port10
Draught Limiter10
Explosion Flap10
Electrostatic Particle Separator10
Combustion Air for Room Air-Dependent Operation12
Combustion Air Supply at the Installation Room12
Simultaneous Operation with Other Air-Drawing Systems12
Combustion Air for Room Air-Independent Operation14
Definition of Terms14
Supply Air Line15
Condensation15
Domestic Hot Water16
Pressure Maintenance Systems17
Storage Tank18
Boiler Ventilation18
Technology19
Dimensions19
Connections20
Technical Specifications21
Peco 15-2021
Peco 25-3022
Peco 32-3523
Boiler Data for Planning the Flue Gas System25
External Suction Module26
Assembly27
Included in Delivery27
Tools Required28
Transport28
Positioning28
Temporary Storage29
Setting up in the Boiler Room30
Moving the Boiler in the Boiler Room30
Operating and Maintenance Areas of the Equipment30
Installing the Boiler31
Remove Boiler from Pallet31
Preparing the Boiler for Transport and Setup (Boiler Type 25-35)32
Aligning the Boiler on the Floor33
Prepare for Room Air-Independent Operation34
Install the Protective Plate for the Flue Pipe35
Attaching the Maintenance Sticker to the Inside of the Insulated Door35
Installing the Discharge System36
Installing the External Suction Module36
Connect the Suction Hoses to the Boiler38
Assembly Information for Hose Lines39
Electrical Connection41
Board Overview42
Connecting Components43
Potential Equalisation43
Final Installation Steps44
Insulate the Connection Line44
Install the Brackets for Accessories45
Start-Up46
Before Commissioning / Configuring the Boiler46
Initial Startup47
Permitted Fuels47
Non-Permitted Fuels47
Heating up for the First Time47
Decommissioning48
Mothballing48
Disassembly48
Disposal48

Froling PECO - Install the Brackets for Accessories

Table of Contents