until the Cam Follower 41 stops at the correct position.
a. Please also loosen the M6 screws but turn the Cam Roller slightly counterclockwise
If Cam Follower 41 stops beyond the correct position:
Limit Switch Cam 34 while machine is running.
Figure 2
shows the correct position for LS2 Proximity Sensor 33 against the lobes of the
Cam 34 , the machine will stop about 0.3 seconds so that the machine can switch to
Cam 42 as shown in figure 2-1. If the Cam Follower is not at the correct position, please
take-up . In the meantime, Cam Follower 41 has to stay on the corner position of the Tension
When LS2 Proximity Sensor 33 detects Lobe A of the activated running Limit Switch
make the same adjustment as for LS3.
-15-
To Next Page
Loading...
