16
Insert the terminals into the respect-
ive slot until they engage. Fasten the
union nut of the cable gland to a
torque of 4 Nm.
17
Place the cover on the connection
area. Tighten the 5 screws by rotating
them 180° to the right in the indicated
order using a screwdriver (TX20).
18
Clip the housing cover onto the invert-
er from above.
Press on the lower part of the housing
cover and tighten the 2 screws by ro-
tating them 180° to the right using a
screwdriver (TX20).
168
To Next Page
Loading...
