1
TX 20
1,3 - 1,5 Nm
BAT+
BAT-
8
Fasten the screws of the cable guide to
the housing using a screwdriver (TX20)
and a torque of 1.3 – 1.5 Nm.
NOTE!
Risk due to overtorque at the strain-
relief device.
This may result in damage to the
strain-relief device.
▶
Do not use a drill driver.
IMPORTANT!
Information for the battery-side connection can be found in the Installation In-
structions from the relevant manufacturer.
Connecting the
LG FLEX ground
conductor
1
Route the battery ground conductor
into the integrated cable duct of the
connection area divider and into the
AC connection area.
2
Fasten the battery ground conductor
to the second input of the ground
electrode terminal from the top using
a screwdriver (TX20) and a torque of
1.8 – 2 Nm.
IMPORTANT!
Information for the battery-side connection can be found in the Installation In-
structions from the relevant manufacturer.
84
To Next Page
Loading...
