Fronius TransPocket 1500 RC - Frequency Parameter for TIG Pulsed Arc

19
EN
Important! The frequency parameter is only available on the TP 1500 TIG.
The frequency parameter is for setting the frequency of the pulsed arc.
The welding properties achieved in TIG pulsed arc welding are determined to a large
extent by the frequency of the pulsed arc.
- Stage 0 ................Low frequency
- Stage 4 ................High frequency
TP 1500 TIG
60 Hz
4 Hz
2 Hz
1 Hz (factory setting)
0.5 Hz
Important! The table below shows the factory settings for the parameters described
above.
„Arc-force“ „Characteristic“ „TIG comfort-stop“ „Frequency“
TP 1500 TIG 40 A 4 A/V Deactivated 1 Hz
TP 1500 / 1500 RC 40 A 4 A/V - -
The TP 1500 / TP 1500 RC and TP 1500 TIG power sources are completely suitable for
being run on generator power, provided that the apparent power delivered by the gene-
rator is at least 10 kVA.
Note! The voltage delivered by the generator must NEVER overshoot or
undershoot the range shown.
+15%
265 V~195 V~
-15%
230 V~
Fig.14 Tolerance range of the mains voltage
"Frequency"
parameter (for
the TIG pulsed-
arc welding
process)
Table of factory
settings for
parameters
Generator-powered operation
Requirements