Fronius TransTig 800 User Manual

68
IMPORTANT The following points apply to the pulsed welding current:
The power source automatically regulates the pulsing parameters as a function of the pre-
set main current I
1
.
The pulsed welding current begins:
- after the end of the starting-current phase I
S
- with the upslope phase UPS
Depending on what tAC time has been set, the pulsed welding current may continue up to
and including the final current phase I
E
(tAC set-up parameter set to "ON").
After the tAC time has elapsed, welding continues at a constant welding current, and any
pulsing parameters that may have been set continue to be available.

Fronius TransTig 800 Specifications

General

Brand	Fronius
Model	TransTig 800
Category	Welding System
Language	English