13
9. Miscellaneous
Use this screen to configure the CM3000 to be part of a Conductor system for intercom and/or PA.
Intercom/PA Stream Mode configuration
• Checking Intercom device tells the Conductor server that this CM3000 is part of the intercom system.
• Checking Master device tells the Conductor server that this CM3000 has a microphone and is allowed to initiate pages.
This is set only when the CM3000 is part of a Conductor admin station, not when it is simply a part of the intercom system.
• Heard on AMP speakers specifies that intercoms and paging are heard on the ceiling speakers in an ezRoom; when the
CM3000 is part of a head end installation it specifies that intercoms are heard on speakers attached to the CM3000.
• Heard on Intercom speakers specifies that intercoms and paging are heard on the intercom (the CB75) in an ezRoom.
• Save Settings will save any adjustments made in this section.
Push to talk configuration
• PPT Mode refers to a CB75 “push to talk” configuration choices, which are offers Disabled (always handsfree), After push
(initially handsfree), Always (never handsfree).
• Switch assignments should not be used unless you are an experienced audio engineer and are working with unusual
installation requirements.
• Save Settings will save any adjustments made in this section.
IR configuration
• Unless the CM3000 is to be controlled via IR these settings do not apply. Even if controlled via IR these settings will not
likely need to be changed.
INTERCOM Connection configuration
• Rotary Mode is used with a CB75; choose AMP direct if there is no intercom functionality and you want to use the CB75
for local classroom audio control; choose Intercom so the push to talk (PTT) microphone can be used for classroom
intercom; Off disables the rotary knob.
• Save Settings will save any adjustment made in this section.
To Next Page
Loading...
Need help?
General