14
Run Calibration is a legacy feature that doesn’t apply to a CM3000.
10. Enter Command
Use this section to send control commands to a device to verify that it performs the action desired.
Choose the command from the (Select an entry) menu and complete it with device and other specific information in the Send
Command field. Submit it by pressing the Send CMD button.
Control feedback requested in the command sent will be displayed in the Receive Command field if specified within the
control command. If no reply is requested Command successful will be displayed; this only means that the CM3000 successfully
sent the command. In practice, the most salient feedback is gotten by observing the device itself.
See Appendix A for more detailed information on CM3000 commands.
To Next Page
Loading...