12
7. Serial Ports
• The COM Port menu specifies the COM port number that the parameters on this page apply to; the CM3000 has only
one COM port.
• Baud Rate specifies the data speed at which the CM3000 should communicate with the attached serial device; while 9600
and 19.2K are typical for projectors, data speeds vary by manufacturer.
• Stop Bit is specified by the manufacturer but is typically 1.
• Parity is specified by the manufacturer but is typically None.
• Save Settings will save any adjustments made in this section.
8. Streaming
Unless you are an experienced audio engineer and are working with unusual installation requirements, please leave these
parameters set at their default levels.
To Next Page
Loading...
Need help?
General