15
11. Event Definition
The CM3000 is an amplifier, an encoder/decoder for audio over IP and an IP switch, but it can also store predefined commands
that are executed when certain triggers occur. The menu of commands is the same as that shown in the previous screen, and
the following screen shows triggers to initiate commands.
This screen enables associating triggers (numbered 1 through 7, and associated with the New Event field) with commands.
There are navigation buttons to facilitate editing.
Under Alarm one can specify that an alarm sounds when a trigger occurs.
Under Action one specifies the specific command that gets executed when the trigger occurs.
To Next Page
Loading...