Make sure you’ve got everything you need to install your CM3000. By taking the time to prepare, you’ll ensure the actu-
al set up is as quick and problem-free as possible.
1. Visualize your goal
Your CM3000 Networked Amplifier / Controller can be a component of a Conductor IP-based paging system or an ezRoom
classroom AV management system. When your CM3000 is part of an ezRoom installation it might look like this:
Step 1: Before you begin
1
The FrontRow CM3000 is an amplification and control device that is used in ezRoom
®
classroom AV management systems
and in Conductor
™
paging, bell and intercom systems. This one device switches and amplifies analog audio, encodes/
decodes streaming audio, auto switches between local classroom audio and IP audio, includes a four port network switch,
and allows for “pass though” control of serial devices such as a projector. It resides on an IP network so it can be accessed
remotely and securely to execute its functions.
CM3000
Mic dome receiver
HDMI Receiver
CB2000
CB6000
HDMI Audio
Extractor
INSIDE OF THE ENCLOSURE
OR
+12V
+12V
+5V
AV Cable
VGA & video to projector
Projector
Mic Audio
HDMI
Audio
HDMI
Serial
CAT5e
TB14
RCA Audio
PC Audio
CAT5e
LAN
Network +12V
+12VDC
Speaker
Speaker
Audio to ezRoom
ezRoom Installation
To Next Page
Loading...