3–5
melt-cycle mode and remains in this mode until the frypot temperature reaches 180°F (82°C) or the
melt-cycle is cancelled by the operator. If you are not using solid shortening, you may cancel the
melt-cycle.
To cancel the melt-cycle on a full-pot unit, press the right melt-cycle cancel switch . On a split-
pot unit, press the left switch for the left frypot or the right switch for the right frypot.
DISABLING OR ENABLING THE MELT-CYCLE CANCEL SWITCH
The controller can be programmed to disable the melt-cycle cancel switch to prevent accidentally
canceling the melt-cycle.
1. With the controller in the OFF mode, press the melt-cycle cancel switch . The display will
show either "0", meaning that the melt-cycle can be bypassed or a "1" meaning that the melt-
cycle cannot be bypassed.
2. To change the bypass configuration, press and hold the melt-cycle cancel switch for five to six
seconds to toggle the "0" to "1" or "1" to "0". Release the switch when the display shows the
desired setting.
To Next Page
Loading...
