Page 7 of 18
INSTALLATION INSTRUCTIONS
© FS.COM 2016
FS016
For Technical Support: www.fs.com/service.html
2.1.3 Installation Tools
Prepare the following tools before installation:
• Flathead screwdriver
• Phillips screwdriver
• ESD-preventive wrist strap
2.2 Installation
FS S8050 series switch can be installed in the following 2 ways:
• Install the switch into a rack with Front Mounting Brackets (19” standard rack)
• Install the switch on a workbench
2.2.1 Introduction of Mounting Brackets
Mounting Brackets (FS S8050)
Figure 2-1 Appearance Sketch Map of Front Mounting Brackets
Description:
(1) Screw hole for fixing Front Mounting Brackets and rack
(2) Screw hole for fixing Front Mounting Brackets and switch
Front Mounting Brackets are only used to fix switches, but unable to bear the weight.
The installation tools are not provided with FS S8050 Series Switch.
To Next Page
Loading...
