Page 8 of 18
INSTALLATION INSTRUCTIONS
© FS.COM 2016
FS016
For Technical Support: www.fs.com/service.html
2.2.2 Install the Switch into a Rack with Front Mounting Brackets
Installation Process (FS S8050)
Step 1 Wear ESD-preventive wrist strap, and check the grounding and stability of rack.
Step 2 Fix the tray to a proper position of rack horizontally.
Step 3 Take out screw (complete package with front hangers), and install one end of the Front Mounting Brackets on switch,
as shown in Figure 2-2.
Figure 2-2 Installation Sketch Map of Front Mounting Brackets
Step 4 Place switch on the tray horizontally, push it slightly into the rack along the tray, and fix the other end of Front Mounting
Brackets upon the front hold strip of rack using screw and its matching floating nut.
Figure 2-3 Installation Sketch Map of Front Mounting Brackets with Tray
To Next Page
Loading...
