Page 15 of 18
INSTALLATION INSTRUCTIONS
© FS.COM 2016
FS016
For Technical Support: www.fs.com/service.html
3. In the Port item, please choose specified COM port that the PC is using. (Here we take COM4 as an example.)
Figure 4-8 Serial Parameters Setting Interface (Port)
4. Set Baud rate to 115200, Data bits to 8, Parity to None, Stop bits to 1, and Flow control to XON/XOFF. Then click
“Connect” button to enter the Serial display interface.
5. If the network advice is connected with PC via Serial cable, you could see the command line interface (CLI) when you
push down the “Enter” button of the PC.
Figure 4-9 Serial Display Interface
Please use the DB-9 to RJ-45 Console cable which we provide together with this device.
Use the DB-9 to RJ-45 Console cable from other vendors maybe can’t access this device.
4.4 Switch Power-on
After the switch is powered on and starts up, self-check information on equipment will display on the terminal. Users are
prompted to type Enter after self-check, then command line DOS prompts (such as (Switch)) will appear. Type a command,
configure Ethernet switches or view the running state of Ethernet switches. Enter "?" whenever you need a help. See the
subsequent chapters of this manual for specific configuration commands.
To Next Page
Loading...
