FS Fiberstore S8050-20Q4C - Figure 4-3 Connection Port Setting

INSTALLATION INSTRUCTIONS
Page 13 of 18
© FS.COM 2016
FS016
For Technical Support: www.fs.com/service.html
2. Type the name of the new connection in the Name text box (For example: Network) and click “OK”. The following dialog
box appears. Select the serial port to be used from the Connect using drop-down lists.
Figure 4-3 Connection Port Setting
3. When the Network Properties dialog box is displayed as shown in following figure, set Bits per second to 115200, Data bits
to 8, Parity to None, Stop bits to 1, and Flow control to None. (In other windows operating systems, bits per second may be
described as baud rate and data stream control may be described as traffic control.)
4. Click “OK” after setting the serial port parameters and the system enters the HyperTerminal window.
Figure 4-4 HyperTerminal Window