FS Fiberstore S8050-20Q4C - Setting Terminal Parameter (Securecrt from Vandyke Software)

Page 14 of 18
INSTALLATION INSTRUCTIONS
© FS.COM 2016
FS016
For Technical Support: www.fs.com/service.html
5. Click “Properties” in the HyperTerminal window to enter the Network Properties dialog box. Click the Settings tab, set
the emulation to VT100, and then click “OK”.
Figure 4-5 Terminal Emulation Setting
Please use the DB-9 to RJ-45 Console cable which we provide together with this device.
Use the DB-9 to RJ-45 Console cable from other vendors maybe can’t access this device.
4.3 Setting Terminal Parameter (SecureCRT from VanDyke Software)
Install the SecureCRT software on PC.
Set SecureCRT Serial terminal parameters.
1. Click "Quick Connect" button to enter the SecureCRT quick connection window.
Figure 4-6 Create a New Quick Connection
2. Choose the “Serial” as the Protocol.
Figure 4-7 Serial Parameters Setting Interface (Protocol)