Page 12 of 18
INSTALLATION INSTRUCTIONS
© FS.COM 2016
FS016
For Technical Support: www.fs.com/service.html
Chapter 4 Initial Power-on and Start-up of Switch
4.1 Building Configuration Platform and Connecting Cable
Figure 4-1 Building Local Configuration Platform Through Console Port
Connect DB-9 hole-type plug of configuration cable to the serial port for configuring switch.
Connect RJ-45 end of configuration cable to the console port of switch.
Please use the DB-9 to RJ-45 Console cable which we provide together with this device.
Use the DB-9 to RJ-45 Console cable from other vendors maybe can’t access this device.
4.2 Setting Terminal Parameter (Windows Super Terminal)
Turn on PC and run emulator program (eg. Windows system has its own super terminal) on PC.
Set terminal parameters (take the super terminal setting of Windows XP as an example).
1. Click “Start → Program → Attachment → Communication → Super Terminal" to enter the super terminal window and
establish a new connection, then a connection description interface will pop up as the following figure show.
Figure 4-2 New Connection
Console Port
Configuration Cable
RS-232 Serial Port
To Next Page
Loading...
