FS Fiberstore S8050-20Q4C - Chapter 6 Upgrade of Operating System

Page 17 of 18
INSTALLATION INSTRUCTIONS
© FS.COM 2016
FS016
For Technical Support: www.fs.com/service.html
Chapter 6 Upgrade of Operating System
FS S8050 Series Ethernet Switch can support new features and enhance system performance without replacing hardware by
upgrading the operating system.
Figure 6-1 Upgrade Operating System
1. In the privilege mode of switch, use the command COPY to copy the mirror files on TFTP server to the boot directory of
switch flash.
Switch# copy mgmt-if tftp://10.10.29.160/SwitchOS-ma-v3.1.12.it.r.bin flash:/boot/ SwitchOS-ma-v3.1.12.it.r.bin
2. When copying, check if the switch has enough space; if the space is not enough, you can delete redundant mirror.
Set the mirror that will be loaded when switch starts next time.
3. After copying the mirror to a relevant directory of switch, you can use the command boot to set the mirror that will be
loaded when switch starts next time.
Switch(config)# boot system flash:/boot/SwitchOS-ma-v3.1.12.it.r.bin
View the mirror that will be loaded when switch starts next time
After setting the mirror that will be loaded when switch starts next time, you can use the command SHOW to check if the
setting is valid;
Switch# show boot images
System image files list:
Current boot image version: 3.1.12
Create Time Version File name
======================================================================
2011-01-01 15:03:30 3.1.11 SwitchOS-ma-v3.1.11.it.r.bin
* 2011-05-28 10:08:38 3.1.12 SwitchOS-ma-v3.1.12.it.r.bin
Among them, the files marked with * are image files that will be loaded when switch starts next time.
Ethernet
Ethernet Cable
EJ45 Ethernet Port
Management Port
TFTP server
Copy the Upgrading Image File to Switch