FS Fiberstore S8050-20Q4C - Chapter 3 Interface Module and Cable Connection Description

Chapter 3 Interface Module and Cable Connection Description
Page 11 of 18
INSTALLATION INSTRUCTIONS
© FS.COM 2016
FS016
For Technical Support: www.fs.com/service.html
3.1 Interface Module Description
3.1.1 Ethernet Port
FS S8050 series switch is integrated with out-of-band Ethernet ports whose interfaces are 100Base-TX or 10Base-T. It is
recommended to use the net line included.
3.1.2 Console Port
Console port uses an 8-pin RJ-45 connector. When connecting the console port of switch to a computer, we need an RJ-45
to DB-9 adapter cable. It is recommended to use the serial line enclosed in the installation package.
Figure 3-1 DB-9 to RJ-45 Console Cable
Specific pin information can be found in the table below.
Table 3-1 RJ-45 to DB-9 Cable Sequence
RJ-45 Signal Direction DB-9
CTS (Clear To Send)
1
2
3
4
5
6
7
8
DSR (Data Set Ready)
RXD (Receive Data)
GND
GND
TXD (Transmit Data)
DTR (Data Terminal Ready)
RTS (Request To Send)
8
6
2
5
5
3
4
7
→
→
→
---
---
←
←
←