Fugro 3610 - Page 42

SeaSTAR 3610 USER MANUAL
APPENDIX D
Menu interface layout
G
Nearest
on/off
Can only be read, not changed
Can only be read, not changed
Several arrows means that the number of menue items depend of
the number of reference stations actually received on the air
Set GLO L1 sites
Set all GLO L1
<on/off/nearest>
Set site 0280
<on/off>
Set site 0240
<on/off>
Set site 0280
ON
GLO L1 Nearest
Use <5> sites
Set site 0240
<on/off>
Status
Channel
Alarms
Alarmlist
<time and event>
Clear all alarms
Ntrip
Ant. Power On
Position status
LAT xxxx.xxxx N
LON yyyy.yyyy E
Actual freq. [MHz]
Satellite ID
Symbol rate
Time in lockPort A status
Baudrate
GPS enabled/disabled
VBS enabled/disabled
Service ID
Good counts
Bad counts
C/N [dB]
HP/XP enabled/disabled
GLONASS enabled/disabled
IONO disabled/enabled
SCF disabled/enabled
Debug disabled/enabled
Port B status
Antenna output voltage
[VDC]
Same as Port A
L10.0
Lock time
EUSAT
About
Software Version
Subsc. L G
Receiver type
Serial Number
Expire Date
Reset
Factory Defaults
Display config
Contrast
Backlight
<on/off>
Set channel/position
Set channel
Set position
Set antenna power
<on/off>
Set Ntrip
C/N0 [dB-Hz]
Issue 2.0 02/10
32