Page 36 (Load-Cell Connector and Cable Details)

FUJI CONTROLS CP-2 - Load-Cell Connector and Cable Details

36 pages

Save Page as PDF

To Previous Page

To Previous Page

Loading...

- 31 -

Table of Contents

Default Chapter5
How to Make die Matching (Inching Operation)15
Press Hold Sensor Adjustment15
- When Installed to the Air-Press (for the Case of QC Press)15
Position Adjustment Related to Photo Sensor for Press-Fit Load Measurement End Signal16
Stroke Adjustment (Modes 1 and 7 Are Not Used)17
- Various Settings and Changing Method18
Adjustment Related to Press Output and Descending Speed17
How to Verify the Press Output17
Register of Upper/Lower Limit Comparison Value18
Register and Change of Load Value Setting21
3, Time Change of Pressurizing Timer23
Time Change of Cycle Time Error24
Change of Load Measuring Method25
Selection of Press Re-Start Permission26
Change of Control Mode27
Change of Set Value Prohibition Lock28
- Maintenance and Noise Countermeasures32
Maintenance32
Noise Countermeasures32

EasyManua.ls – Your Ultimate Manuals Destination!

With a comprehensive collection of over 1 million PDF manuals, service guides, instruction booklets, and quick start guides, we cover every aspect of your needs. Explore manuals for products from more than 50,000 brands all in one place. Search and instantly view the manual you’re looking online for free.

Privacy Policy
Contact Us

© Copyright 2025 EasyManua.ls. All Rights Reserved.