- 18 -
3, Time change of pressurizing timer
This is a changing operation of time for pressurizing timer. (Initial value: 1.0 second)
1. Push ４
TIMER
key
Letters [ marked with mesh is flashed.
In the case that letters other than are displayed, pus
h either RESET key or correct key.
.
2. Push ＳＥＴ／ＣＨＧ key
. ← Figure flashing is the place waiting for input.
← This is the pressurizing time (seconds) so far.
.
Please input new time by using ten-key (from upper to lower rank figure).
When “1.5 seconds” is changed to “2 seconds,” please input “ ２ ” and “ ０ ”.
If pressurizing time is determined, proceed to the following procedure.
3. Push ＳＥＴ／ＣＨＧ key
←This is the new pressurizing time.
.
Pressurizing time has finally been changed.
◎If RESET key is pushed prior to pushing ＳＥＴ／ＣＨＧ key in the above 3, all operations made so far are
cancelled. Please return to the above 1 and carry out all procedures again.
Important: CP-2-003 (load-cell of 3kN rating loads is used) displays down to three decimal points.
To Next Page
Loading...