2-5
(2) For inverters with a capacity of 7.5 and 10 HP
To remove the terminal cover, first loosen the terminal cover fixing screw on it, and put your
finger in the dimple of the terminal cover (labeled "PULL"), and then pull it up toward you.
To remove the main circuit terminal block cover, put your thumbs on the handles of the main
circuit terminal block cover, and push it up while supporting it with your fingers. (Refer to Figure
2.5.)
Figure 2.5 Removing the Covers (For Inverters with a Capacity of 7.5 and 10 HP)
When mounting the main circuit terminal block cover, fit it according to the guide on the
inverter.
Figure 2.6 Mounting the main circuit terminal block cover
(For Inverters with a Capacity of 7.5 and 10HP)
To Next Page
Loading...
